63 Results: New & Used in Boat Accessories & Parts in Australia

• Evinrude

ETEC 175 819 hours 2010 Has just been serviced with paperwork Replaced fuel pump with paperwork Upgrading the motor next week Motor comes with the 2gauges, harness etc

• Evinrude

Short shaft, runs great, always been in the family , rarely used over past 6 years , new plugs

• Evinrude

2007 Evinrude E-Tec E200DPXSUF Approximately 650 hours Two injectors need replacing Recently serviced. SS prop New stator ($800), new flywheel ($1700), new impeller recently installed.

• Evinrude

Evinrude E-TEC ETEC 200 Outboards. One counter rotating. Low hours. 2006 Model salt water series. Great condition. Ready to go mounted on Pallets. Location Yellingbo. Can help with Transport. Comes with controls props, cables, gauges, oil tanks etc.

• Evinrude

22.7 litres fuel tank good condition pick up only Chambers Flat

• Evinrude

50hp Evinrude ,Runs great, always serviced.

• Dealer
• Evinrude

Evinrude Etec 130hp XL (25” leg) Outboard Motor. Great running engine. Has been checked over and serviced by Port Douglas Marine. FNQ Evinrude dealer. Compressions all even on cylinders. Comes with digital I-Command gauges and control box. Printout available on request. 423hours. Flywheel and exhaust valve recently replaced. Can fit engine onsite or ship Australia wide!!

• Evinrude

Good condition 520hrs 4 Blade prop 2020 Model

• Evinrude

Johnson evinrude propeller fully refurbished Bare alloy respray etched primer 2k undercoat 3 coats of 2k top coats Looks as new all blades perfect condition, 12 1/4× 15 suit 50 55 60 hp omc motors 13 spline

• Evinrude

Comes with forward controls and all wiring shown in last picture Still starts and runs strong. Can show videos fro. This summer. It's all still connected up so can start engine for you. Price is cheap because I bought boat to restore and wanted new engine. So I don't need top dollar. Can help with removal from boat. Pick-up is hoppers crossing

• Evinrude

75 Hp Evinrude Etec 2 stroke efi outboard motor in excellent original condition. Runs extremely well pumps plenty of water with no over heating & sounds very healthy with plenty of grunt .This motor has been well maintained & looked after & is amazing on fuel just like a 4 stroke but with the 2 stroke punch & much lighter in weight. 2010 model fuel injected Oil injected ( no pre mixing required) Genuine 214 hours (ecu print out available) Control box with all cables Gauges Stainless steel viper

• Evinrude

2014 Evinrude E-TEC 200HO. This incredible outboard has amazing low down power, is super smooth and quiet and amazingly fuel efficient.

• Evinrude

Outboard motor, Evinrude 9.9 hp , long shaft, complete motor, last run 5 years ago perfectly, it is a very clean unit but selling as it is and comes with trolley stand, the price is firm $250 , Croydon Park NSW

• Evinrude

2009 model 90Hp Evinrude etec Good condition reliable motor Brand new throttle binnacle Comes with gauges and accessories

• Dealer
• Evinrude

2012 Evinrude - E130DPXINA (130hp) 2 stroke Fully serviced (price does not include fitting)

• Evinrude

twin 70hp evinrude 2 strokes stainless steel props, tilt trim, gauges, controls, cables. full serviced 6 months ago... carbies mite need cleaning. sprayed black to match the boat, only selling due to an upgrade. going to have them stripped within a week already have the other motors... 3500 for both

• Evinrude

I have a 40hp johnson everude I have owned it for 2 years the last owner put 2 new coils in it and cleaned the carby I have never started it so not sure how it works , due to injuries unable to finish project make me a offer

• Evinrude

Evinrude Etec 150 Outboard Engine. This engine is a 2009 model with only 285 hours and running beautifully. Comes with control, 2 gauges, oil tank and stainless steel prop. Hydraulic tilt and trim. Selling only due to upgrade. Located in Hervey Bay

• Evinrude

1993 evinrude 8hp twin cylinder long leg. Just been serviced with new gearbox oil and new water pump. Runs perfectly, comes with 23l plastic fuel tank and hose. Can be seen running on pick up

• Dealer
• Evinrude

Looking at giving your Evinrude ETEC outboard a bit of a birthday? We have plenty of genuine cowlings for your ETEC, in great condition. New or used stock, send through what your needing and we will have a look and see what we can provide for you. Chivers Marine are WA’s oldest and most committed name in boating. Our Team has more than 100 years combined experience in the West Australian marine industry making our team one of the most knowledge and competent you can trust when it comes to yo